WoodCore WPC patio planks - patio planks with 15 years warranty

WoodCore WPC decking boards

WoodCore WPC decking boards are made from a composite material - a mixture of wood particles, HDPE thermoplastic filler and additional additives. These WPC decking boards are more resistant to water, UV radiation and biological, chemical and mechanical environmental influences. Their great advantage over tropical wood is their long service life and minimal maintenance, which makes them the ideal solution for outdoor landscaping, balconies and gardens.

Easy installation of a WoodCore WPC wood composite terrace

The installation of WoodCore WPC decking boards is easy thanks to the spacers. For the installation of WoodCore WPC, common household tools are sufficient. With WoodCore WPC spacers, visible and protruding screws are a thing of the past and this is what makes a WPC terrace friendly to bare feet.

Warning: failure to follow the installation instructions may invalidate the warranty. Installation of WoodCore WPC is not suitable when the outside temperature is below +5 °C.

Installation of WPC terrace boards with clip system on the substructure
WoodCore WPC decking boards ribbed profile - installation example
WPC terrace finishing moulding - aesthetic edge

The height of the substructure and the WPC terrace boards is 5.5 cm, or 6.5 cm if the substructure is inverted.

Elements for WoodCore WPC terraces:

WoodCore WPC decking boards classic profile, ribbed surface

CLASSIC

WoodCore WPC decking boards.
Dimensions: 150 x 25 x 4000 or 2200 mm

Available in five colour shades.

WoodCore WPC terrace boards rustic profile, old wood look

RUSTIC – aged wood look

WoodCore WPC decking boards RUSTIC. One side of the board is smooth, the other is ribbed.
Dimensions: 150 x 25 x 4000 or 2200 mm

 

WPC substructure for terrace - load-bearing element

WPC support joist for terrace substructure.
Dimensions: 40 x 30 x 2200 mm.

Alu base tube

Aluminium joist for terrace substructure.
Dimensions vary depending on the desired height. The length is always 6 m.

WPC terrace finishing bead 45x55 mm

Corner trim L-profile for the terrace.
Dimensions: 45 x55 x 4000 mm or 45 x55 x 2200 mm
(different lengths may be from different series)

Woodcore Roksal element

Stainless-steel starter clip – used where no finishing L-profile is installed

Woodcore Roksal spacer

Plastic spacer

rf screw Woodcore Roksal

Stainless‑steel screw

Colours and surfaces of terrace boards

Choose from seven colour shades and three finishes. The planks have thicker ribs on one side and wide ribs on the other. Rustic planks are completely smooth on one side and have narrow ribs on the other.

Colour palette of shades of WPC boards for board 150

Storage

Before installation, WoodCore WPC boards must be stored in a dry and well-ventilated place. The storage surface must be flat and clean. The boards must be fully supported along their length and width. In the case of improper storage, complaints cannot be accepted.

Send enquiry for WPC decking boards

Get a free quote. Let us know the dimensions of your terrace. If possible, attach photos of the current condition, a floor plan or a sketch.

You can send your enquiry to info@roksal.com or just use the form below: 

Frequently Asked Questions

The price of a WPC terrace depends on the chosen shade, existing sub-surface, required construction, and the scope of installation – which varies based on the terrace's distance, complexity, and size. Instead of just the square meterage, please send the terrace dimensions so you can receive a realistic laying proposal and an accurate quote.

The 4m long board stretches 12 mm (approx. -30 degrees to +40 degrees).

Standard height is 5.5 or 6.5 cm - the board is 2.5 cm thick + 3×4 cm backing strip.

Minimum terrace height can be 4.5 cm - the board is 2.5 cm thick + 2 cm aluminium tube.

The most optimal substrate is a concrete slab with a drop. The substrate is stable and cleaning is easy.

If the battens are 33-35 cm apart (centre), warping of the boards cannot occur.

The boards must also be properly secured with spacers. 

The boards can also be twisted if the terrace has unevenness and WPC underlay strips have been used. In case of unevenness, we recommend the use of aluminium underlay tubes.

Minimum 1 cm per metre.
A slope is necessary to allow water to drain along the boards. 

If the substrate is flat, the drop should be made with a substructure.

If not enough drop is made, water can be expected to pool inside the boards over time, which in turn can cause the boards to crack. This is not covered by the guarantee.

Our laying proposal depends on several factors, the efficiency of the boards and also the drop, if there are any special features.

Most of the water runs off the boards. The underlay battens should be laid with a slight offset and can be supported with rubber strips to ensure water drainage.

If the boards are laid perpendicular to the drop, it is necessary to ensure that water does not collect in the board. We recommend cutting each board at a 5 degree angle so that water drains over the edge and does not flow into the board.
Each board must be drilled from the underside, about 5 cm from the edge, into each compartment (4,2 mm) to allow water entering the board to drain out. 

The dirt that accumulates between the boards is best removed with a high-pressure cleaner and plenty of water. Direct the jet between the gaps and move towards the end of the terrace. The L-profile is a few millimetres shorter to allow the water and dirt to drain away.

WoodCore boards are not resistant to heavy loads, scratches and impacts, so areas where heavy loads may occur need to be reinforced. Narrow legs on patio chairs and tables are not recommended as they may damage the edges of the boards. Any pebble residues on the shoes may scratch the floor covering.

When moving furniture, use appropriate protective pads, and attach dedicated protective felt pads to the legs of chairs, tables, and other furniture to prevent permanent deformation and indentation of the floor surface. Remove all sharp objects that could mechanically damage the surface of the flooring.

Smooth sides of boards are more likely to have visible scratches than grooved sides.

WPC decking boards

Want to see more examples? Browse our full terrace gallery.

Advantages of WPC decking boards

WPC decking boards combine the beautiful look of natural wood with the durability of modern materials. Their biggest advantage is that they do not need painting or oiling, which saves owners time and costs. They are also resistant to moisture, mould and pests, making them suitable for all weather conditions. You can also read more about the material at WPC Wikipedia.

Why choose WPC for your terrace

A WPC terrace retains its shape and colour even after many years of use. The surface is non-slip and safe to walk on, making it suitable for families with children or by the pool. The material does not split or crack like wood, so it is comfortable to use even with bare feet. With a 15-year warranty, WPC Terrace is a long-term and sustainable solution.

THE BIG AUTUMN CAMPAIGN

up to -30 % on WPC DESKE*

No such discounts during high season -
if you're thinking about a terrace, facade or fence
 take advantage of the autumn campaign.

SALE is valid until stocks last 2025.

Stock is limited - on a first-come, first-served basis,
rather a choice. The next delivery will not be until 2026.

*Discounts vary depending on the profile.

June

SALE

up to -30%

-30% discount on WPC decking boards
2.2 m lengths
and a -15% discount on WPC deck boards
4 m length;
regardless of the amount.

Offer valid until 06/30/2025 or.
to clear stock.